MCNOs/CdS双效光催化剂的制备及其性能研究

水热合成法制备了不同磁性纳米洋葱碳(MCNOs)负载量(0%、1%、3%、5%)的MCNOs/CdS光催化剂。并通过X射线衍射分析(XRD)、扫描电子显微镜(SEM)、傅里叶红外光谱(FT-IR)、X射线光电子能谱(XPS)、紫外可见光光谱(UV-Vis)、磁滞回线测定仪(VSM)对其进行表征,探究了MCNOs负载比例对催化剂在可见光下降解RhB性能及机理的影响。结果表明,MCNOs能有效提高CdS的光催化效果,复合3%MCNOs后降解率为96%,与纯CdS相比降解率提高了30%,磁性分析表明,其具有良好的顺磁性并能实现催化剂的有效回收。MCNOs/CdS在可见光下催化降解RhB的一级反应动力学直线有较好的拟合度,表明制备的催化剂有较好的催化活性。     

单面柱局域共振声子晶体低频带隙特性分析及结构改进研究

基于有限元法对单面柱局域共振声子晶体进行带隙特性分析,研究了结构参数对该类型声子晶体的影响。结果表明:随着散射体高度的增加,单面柱声子晶体的第一完全带隙的起始频率逐渐降低,带宽逐渐增大;随着基板厚度的增大,单面柱声子晶体的起始频率逐渐升高,截止频率先增大后减小。并且在经典单面柱声子晶体的基础上,组合了两种新型的三组元单面柱声子晶体结构:嵌入式单面柱声子晶体(以下简称结构Ⅰ)和粘接式单面柱声子晶体(以下简称结构Ⅱ)。通过对其带隙特性的分析得出:这两种新结构与经典的单面柱声子晶体相比,都具有更低频的带隙,这对于低频减振降噪是非常有利的。本文的结果将对实际的工程应用提供一定的理论指导。     

Capillary electrophoresis-acid barrage stacking online enrichment method for highly sensitive determination of four isoflavones

A capillary electrophoresis-acid barrage stacking online enrichment method has been established to detect the four isoflavones which are Daidzein, Genistein, Formononetin, and Biochanin A. The proposed method was optimized using a single factor alternative method, and the optimal conditions obtained from the optimization were: the BGE was 25 mM borax and 2 mM β-cyclodextrin, the applied separation voltage was 20 kV, and the detection wavelength was 260 nm. The time ratio of the injection of sample and the injection of acid was 150 s:20 s, and the acid used was 250 mM acetic acid. The sample solvent used was 60% v/v acetonitrile. The established method had the enrichment factor of these four isoflavones at 24.5, 32.0, 29.2, and 33.7, respectively, LOD and LOQ are as low as nanograms per milliliter. Finally, the CE-acid barrage stacking method was successfully applied to the determination of four isoflavones in rat plasma and red clover extract, verifying the applicability and feasibility of the method.     

TFSI钝化晶体硅表面性质的第一性原理研究

晶体硅表面钝化是高效率晶体硅太阳能电池的核心技术,直接影响晶体硅器件的性能。本文采用第一性原理方法研究了一种超强酸-双三氟甲基磺酰亚胺(TFSI)钝化晶体硅(001)表面。研究发现,TFSI的四氧原子结构能够与Si(001)表面Si原子有效成键,吸附能达到-5.124 eV。电子局域函数研究表明,TFSI的O原子与晶体硅表面的Si的成键类型为金属键。由态密度和电荷差分密度分析可知,Si表面原子的电子向TFSI转移,从而有效降低了Si表面的电子复合中心,有利于提高晶体硅的少子寿命。Bader电荷显示,伴随着TFSI钝化晶体硅表面的Si原子,表面Si原子电荷电量减少,而TFSI中的O原子和S原子电荷电量相应增加,进一步证明了TFSI钝化Si表面后的电子转移。该工作为第一性原理方法预测有机强酸钝化晶体硅表面的钝化效果提供了数据支撑。     

A Neural Network-Based Policy Iteration Algorithm with Global $$H^2$$ -Superlinear Convergence for Stochastic Games on Domains

In this work, we propose a class of numerical schemes for solving semilinear Hamilton–Jacobi–Bellman–Isaacs (HJBI) boundary value problems which arise naturally from exit time problems of diffusion processes with controlled drift. We exploit policy iteration to reduce the semilinear problem into a sequence of linear Dirichlet problems, which are subsequently approximated by a multilayer feedforward neural network ansatz. We establish that the numerical solutions converge globally in the \(H^2\)-norm and further demonstrate that this convergence is superlinear, by interpreting the algorithm as an inexact Newton iteration for the HJBI equation. Moreover, we construct the optimal feedback controls from the numerical value functions and deduce convergence. The numerical schemes and convergence results are then extended to oblique derivative boundary conditions. Numerical experiments on the stochastic Zermelo navigation problem are presented to illustrate the theoretical results and to demonstrate the effectiveness of the method.

     

n型IBC太阳电池选择性发射极工艺研究

为提升n型叉指背接触(IBC)太阳电池的光电转换效率,采用丝网印刷硼浆和高温扩散的方式形成选择性发射极结构,研究了硼扩散和硼浆印刷工艺对电池发射极钝化性能和接触性能的影响。实验结果表明,在硼扩散沉积时间和退火时间一定的条件下,硼扩散通源(BBr₃)流量为100 mL/min,沉积温度为830 ℃,退火温度为920 ℃时,发射极轻掺杂(p⁺)区域的隐开路电压达到710 mV,暗饱和电流密度为12.2 fA/cm²。发射极局部印刷硼浆湿重为220 mg时,经过高温硼扩散退火,重掺杂(p⁺⁺)区域的隐开路电压保持在683 mV左右,该区域方块电阻仅46 Ω/□,金属接触电阻为2.3 mΩ·cm². 采用该工艺方案制备的IBC电池最高光电转换效率达到24.40%,平均光电转换效率达到24.32%,相比现有IBC电池转换效率提升了0.28个百分点。     

Two-dimensional Covalent Organic Frameworks: Intrinsic Synergy Promoting Photocatalytic Hydrogen Evolution

Covalent organic frameworks(COFs) are emerging photocatalysts for hydrogen evolution in water splitting in recent years. They offer a pre-designable platform to design tailor-made structures and chemically adjustable functionality in terms of photocatalysis. In this review, we summarize the recent striking progress of COF-based photocatalysts in design and synthesis. Firstly, different approaches to functionalizing building blocks, diversifying linkages, extending π-conjugation and establishing D-A conjugation are illustrated for enhancing photocatalytic activity. Next, post-modification of backbones and pores is detailed for emphasizing the synergistic catalytic uniqueness of COFs. Besides, the strategy of preparing COF-related composites with various semiconductors is outlined for optimizing the electronic properties. Finally, we conclude with the current challenges and promising opportunities for the exploration of new COF-based photocatalysts.     

(Sm0.5Gd0.2Nd0.3)2(Hf0.3Ce0.7)2O7复合氧化物的热物理性能

为寻求新型热障涂层用陶瓷材料,本文采用高温固相烧结法制备了(Sm_0.5Gd_0.2Nd_0.3)₂(Hf_0.3Ce_0.7)₂O₇复合氧化物。利用XRD分析了其晶体结构,SEM分析其显微组织,膨胀仪测试其热膨胀性能,激光热导仪测试其热扩散系数。结果表明,成功制备了具有单一萤石晶体结构的(Sm_0.5Gd_0.2Nd_0.3)₂(Hf_0.3Ce_0.7)₂O₇复合氧化物。其显微组织结构致密,晶界清晰无其他相存在。由于复杂的元素组成和较大的原子量,其热导率明显低于7YSZ和Sm₂Ce₂O₇。其较低的热膨胀系数则归因于B位离子较小的离子半径,但其热膨胀系数依然满足热障涂层的要求。